critical failure
英 [ˈkrɪtɪkl ˈfeɪljə(r)]
美 [ˈkrɪtɪkl ˈfeɪljər]
网络 致命故障; 危急故障; 致命性失效
双语例句
- Based on the analysis of distortion features of casing under heterogeneous external pressure by the software of ANSYS, the critical heterogeneous external pressure is determined after defining the critical failure conditions under this condition.
通过ANSYS有限元软件分析了套管在非均匀外挤力作用下的大变形特征，定义了套管在非均匀外挤力作用下破坏的临界条件，得到了此时的临界非均匀外挤力。 - Study on Critical Failure Vibration Velocity of Underground Chambers under Action of Blasting Vibration
爆破振动作用下地下洞室临界振速的研究阿尔瓦雷兹加速撇振腔 - From limit state of reduced safety factor, choosing canonical different maximum possible safety factors and their corresponding critical failure probabilities to build the division chart of landslide stability.
在折减后的安全系数的极限状态中，根据典型的不同最大可能安全系数及相应的临界破坏概率，建立了二元滑坡稳定性分区，用于滑坡稳定性评价。 - Based on genetic algorithm and Bishop's method, searching methods of circular sliding surface applied widely in engineering for the critical failure surface are presented and the minimal safety factor is located accordingly.
基于遗传算法和Bishop法，对工程实践中最为广泛应用的圆弧滑裂面提出了搜索临界滑移面及相应最小安全系数的方法。 - Based on genetic algorithm and Sweden method of slices, this paper puts forward the searching methods of critical failure surface and minimum safety factor in slope.
在遗传算法和瑞典条分法的基础上，提出了对边坡临界滑裂面的搜索方法及其最小安全系数的求解方法。 - This paper for 14 kinds of major common accident define and analyse critical failure deliver because of factor, at the same time for major professional harm factor, argue to know, analyse.
本论文对主要常见的14种事故进行定义并分析主要事故致因因素，同时对主要的职业危害因素进行辩识、分析。 - The key of strength reduction method is how to define the critical failure state of slope.
强度折减有限元方法分析边坡的关键问题是临界破坏状态的确定。 - Several calculating formulae for critical failure force are proposed for engineering purposes.
提出了便于翻管工程计算中几种临界失稳力的计算式； - Traditionally, the searching of critical failure surface is mostly confined in arc surface, and is prone to be dependent on initial value, inevitably often lost in local extremum, furthermore it is hardly capable to perform in three dimension slope problems.
传统的极限平衡搜索，多数为近似的圆弧滑动面搜索，且搜索初值选择过分依赖于工程经验，结果也容易陷入局部极小点，在三维问题中更是无能为力。 - Because it is a pure P2P-based system, there will be no critical failure point and it is loaded equivalently any time anywhere, in this way, it is more robust than traditional C/ S-based system.
由于完全采用P2P技术设计与实现该系统，在任何时刻，系统均不存在单点故障问题及负载不均衡问题，与传统的基于C/S模式的系统相比，该系统的运行更加稳定可靠。